TGAP-W6610+ is a reliable outdoor wireless Access Point with dual RF IEEE 802.11 a/b/g/n wireless modules and 1 Ethernet Gigabit port with PoE P.D.. It can be configured to operate in AP/ Client /Bridge /AP-Client Mode and supports MAC filters for security control. TGAP-W6610+ provides a dust-tight connection and four N-Type connectors that can install any N-Type antennas to extend communication distance. It is specifically designed for the toughest industrial environments. You are able to configure TGAP-W6610+ by WEB interface via LAN port or WLAN interface. In addition, TGAP-W6610+ also provides P.D. feature that is fully compliant with IEEE802.3af PoE P.D. specification to save the layout cost of power line. TGAP-W6610+ can be easily adopted in almost all kinds of applications and provides the most rugged solutions for managing your network in outdoor. Therefore, TGAP-W6610+ is one of the best communication solutions for wireless applications.
Feature :
- High Speed Air Connectivity: RF in IEEE 802.11 a/b/g/n WLAN interface support up to 300Mbps link speed
- Dual RF for redundant wireless communication
- Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK(TKIP,AES)/802.1X Authentication supported
- Support Long Distance Air Connectivity
- Support Multiple-SSID to 4 SSID
- Support X-Roaming < 60 ms
- Support wireless load balance
- Support external N-Type antenna installation
- Support AP/ Client /Bridge /AP-Client Mode
- Support MAC/IP/Port Filter
- Wireless connecting status monitoring
- Secured Management by HTTPS
- 1KV isolation for PoE P.D.
- Event Warning by Syslog, Email, SNMP Trap, and Beeper
- Rigid IP-67 waterproof housing design
Specification :
TGAP-W6610+ | TGAP-W6610+-M12 | ||
Physical Ports | |||
10/100/1000Base-T(X) Auto MDI/MDIX |
1(RJ45) | 1(M12 8-pin A-coding) | |
PoE P.D. port | Present at ETH Fully compliant with IEEE 802.3af Power Device specification Over load & short circuit protection Isolation Voltage: 1000 VDC min. Isolation Resistance : 108 ohms min |
||
WLAN interface | |||
Operating Mode | Dual AP/Dual Client /Bridge /AP-Client Mode | ||
Antenna and connector | 4 x External N-Type female antenna connector | ||
Radio Frequency Type | DSSS, OFDM | ||
Modulation | IEEE802.11a : OFDM with BPSK, QPSK, QAM, 64QAM IEEE802.11b: CCK, DQPSK, DBPSK IEEE802.11g: OFDM with BPSK, QPSK, 16QAM, 64QAM IEEE802.11n : BPSK, QPSK, 16-QAM, 64-QAM |
||
Frequency Band |
America / FCC : 2.412~2.462 GHz (11 channels) |
||
Transmission Rate | IEEE802.11b: 1 / 2 / 5.5 / 11 Mbps IEEE802.11a/g: 6 / 9 / 12 / 18 / 24 / 36 / 48 / 54 Mbps IEEE801.11n: up to 300Mbps |
||
Transmit Power | 802.11a: 12dBm ± 1.5dBm 802.11b: 17dBm ± 1.5dBm 802.11g: 15dBm ± 1.5dBm 802.11gn HT20: 13dBm ± 1.5dBm@150Mbps 802.11gn HT40: 12dBm ± 1.5dBm@300Mbps 802.11an HT20: 12dBm ± 1.5dBm@150Mbps 802.11an HT40: 12dBm ± 1.5dBm@300Mbps |
||
Receiver Sensitivity | 802.11a: -68dBm ±2dBm@54Mbps 802.11b: -85dBm ±2dBm@11Mbps 802.11g: -68dBm ±2dBm@54Mbps 802.11gn HT20: -68dBm ±2dBm@150Mbps 802.11gn HT40: -68dBm ±2dBm@300Mbps 802.11an HT20: -68dBm ±2dBm@150Mbps 802.11an HT40: -68dBm ±2dBm@300Mbps |
||
Encryption Security | WEP: (64-bit ,128-bit key supported) WPA/WPA2 :802.11i(WEP and AES encryption) WPAPSK (256-bit key pre-shared key supported) 802.1X Authentication supported TKIP encryption |
||
Wireless Security | SSID broadcast disable and enable | ||
Protocol Support | |||
Protocol | ARP,BOOTP, DHCP, DNS, HTTP, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP, RSTP | ||
LED Indicators | |||
Power Indicator | 3 x LEDs, PW1/PW2/PoE Green On : Power is on and booting up | ||
10/100/1000TX M12 Port Indicator | 1 x LEDs, Green for port Link/Act | ||
WLAN LEDs | 2 x LEDs, Green for WLAN Link/Act | ||
Fault | 1 x LED, Red for Ethernet link down or power down indicator | ||
Power | |||
Redundant Input Power | Dual Power Inputs. 12~48 VDC | ||
Power Consumption (Typ.) | 11 Watts | ||
Physical Characteristic | |||
Enclosure | IP-67 | ||
Dimension (W x D x H) | 310 (W) x 310(D) x 87 (H) (12.2 x 12.2 x 3.4 inch) | ||
Weight (g) | 3980 g | ||
Environmental | |||
Storage Temperature | -40 to 85°C (-40 to 185°F) | ||
Operating Temperature | -25 to 70°C (-13 to 158°F) | ||
Operating Humidity | 5% to 95% Non-condensing | ||
Regulatory approvals | |||
EMI | FCC Part 15, CISPR (EN55022) class A, EN50155 (EN50121-3-2, EN55011, EN50121-4) | ||
EMS | EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS), EN61000-4-8, EN61000-4-11 | ||
Rail Traffic | EN50155 | ||
Shock | IEC60068-2-27, EN61373 | ||
Free Fall | IEC60068-2-31 | ||
Rail Traffic | EN50155 | ||
Vibration | IEC60068-2-6, EN61373 | ||
Rail Traffic | EN50155 | ||
Cooling | EN60068-2-1 | ||
Dry Heat | En60068-2-2 | ||
Safety | EN60950-1 | ||
Warranty | 5 years |