Oring IAR-120 Industrial 802.11b/g Access Point 3.5G VPN Router

by | Jun 20, 2015 | ORing

Oring IAR-120IAR-120/120+ is a reliable 802.11b/g WLAN Access Point with 2 ports 10/100TX ports router where ETH1 for LAN ETH2 for WAN. It could be confi gured to operate in 3 modes of routing function: Dynamic/Static IP route, PPPoE authentication, and Modem (56K/GPRS/3G/3.5G Modem) dial up. In the mode of Modem dial up, it support both traditional 56K modem and GPRSG/3G/3.5G Modem with USB interface. Users can set up WLAN environment to fulfi ll demands of various applications rapidly by dialing up cellular modems. In addition, IAR-120+ also provides PD feature on ETH2 which is fully compliant with IEEE802.3af P.O.E PD specifi cation. This feature extends the layout up to 100 meters. Therefore, IAR-120/120+ are one of the best solution for applications of wireless communication.

Feature :

  • High Speed Air Connectivity: WLAN interface support up to 54Mbps link speed
  • Provide HNAT enhance LAN to WAN routing performance
  • Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/WPA2/WPA2-PSK(TKIP,AES)/802.1X     Authentication supported
  • Secured Management by HTTPS
  • Support STP(802.1D) for wireless redundancy
  • Various kind of WAN Connection Type supported: Dynamic/Static IP, PPPoE, Modem/Dial Up
  • Support client operating mode
  • IP table to prevent access from unauthorized IP address
  • Support VPN for secured network connection (Open VPN , PPTP VPN)
  • Support NAT Setting (Virtual Server , Port Trigger , DMZ , UPnP)
  • Support DHCP forwarder through PPTP function
  • 3G Modem signal information display (un-connecting status)
  • Wireless connecting status monitoring
  • Versatile modes & event alarm by e-mail
  • USB interface support 3.5G HSDPA USB Modem dial up
  • 1KV isolation for PoE P.D. port of IAR-120+
  • Event Warning by Syslog, Email, SNMP Trap, Relay and Beeper
  • Rigid IP-30 housing design
  • DIN-Rail and wall mounting enabled

Specification :

IAR-120 IAR-120+
Physical Ports
10/100Base-T(X) Ports in RJ45 Auto MDI/MDIX                                                                                     2
P.O.E. PD port Present at ETH2
Fully compliant with IEEE 802.3af   Power
Device specifi cation
Over load & short circuit protection
Isolation Voltage: 1000 VDC min.
Isolation Resistance : 10^8 ohms min
USB Host port 1x USB 2.0 Host port
WLAN interface
WAN Connection Type Static/Dynamic IP / PPPoE / Modem (56K/GPRSG/3G/3.5G Modem) dial up
Antenna and connector 2dBi antenna on reverse SMA connector
Radio Frequency Type DSSS
Modulation IEEE802.11b : CCK, DQPSK, DBPSK
IEEE802.11g : OFDM with BPSK, QPSK, 16QAM, 64QAM
Frequency Band America/FCC : 2.412~2.462 GHz (11 channels)
Europe CE/ETSI : 2.412~2.472 Ghz (13 channels)
Transmission Rate IEEE802.11b : 1/ 2/ 5.5/ 11 Mbps
IEEE802.11g : 6/ 9/ 12/ 18/ 24/ 36/ 48/ 54 Mbps
Transmit Power IEEE802.11b/g : 18dBm
Receiver Sensitivity -81dBm @ 11Mbps, PER< 8%;
-64dBm @ 54Mbps, PER< 10%
Encryption Security WEP : (64-bit ,128-bit key supported)
WPA :
WPA2 : 802.11i(WEP and AES encryption)
WPAPSK (256-bit key pre-shared key supported)
Radius supported
TKIP encryption
Wireless Security SSID broadcast disable
Modem Support
List USB modems and ISDN adapters which support the Communication Device Class Abstract Control Model interface
List of tested device :
Hummingbird huc56s (Conexant)
Huawei E220/E230
Simense HSDPA-180C
Prolific 2303 + serial modem
Quanta MUQ101
Sony Ericsson MD400/MD400g
Sierra C885
LED Indicators
Power Indicator PWR 1(2)(P.O.E.) / Ready :
Red On : Power is on and booting up.
Green On : Power is on and functioning Normally.
10/100TX RJ45 Port Indicator Green for port Link/Act at 100Mbps. Amber for port Link/Act at 10Mbps.
WLAN LEDs WLAN Link /ACT : Green : Link, Orange : Poor signal
WLAN Strength : 1<25%, 2<50%, 3<75%, 4<100%
Fault Red : Ethernet link down or power down
LED Indicators
Relay Relay output to carry capacity of 1A at 24VDC
Power
Redundant Input Power Dual DC inputs. 12-48VDC on 6-pin terminal block
Power Consumption (Typ.) 6 Watts
Overload Current Protection Present
Reverse Polarity Protection Present on terminal block
Physical Characteristic
Enclosure IP-30
Dimensions (W x D x H) 52(W) x 106.1(D) x 144.3(H) mm (2.05×4.18×5.68 inch.)
Weight (g) 803 g 807 g
Environmental
Storage Temperature -40 to 85°C (-40 to 185°F)
Operating Temperature -10 to 70°C (14 to 158°F)
Operating Humidity 5% to 95% Non-condensing
Regulatory Approvals
EMI FCC Part 15, CISPR (EN55022) class A
EMS EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS),
EN61000-4-8, EN61000-4-11
Shock IEC60068-2-27
Free Fall IEC60068-2-32
Vibration IEC60068-2-6
Safety EN60950-1
Warranty 3 years

Related Posts