TGAP-6620-M12 is a reliable WLAN Access Point with 2 Ethernet Gigabit ports and dual RF in IEEE 802.11 a/b/g/n wireless modules. It can be configured to operate in Dual AP/Dual Client /Bridge /AP-Client Mode. In combination with its IP-40 design and the superb management functionality, TGAP-6620-M12 provides a dust-tight connection and reverse SMA-type connectors, that can install any reverse SMA-type antennas to extend communication distance. It is specifically designed for the toughest industrial environments. You are able to configure TGAP-6620-M12 by WEB interface via LAN port or WLAN interface. TGAP-6620-M12 can be easily adopted in almost all kinds of applications and provides the most rugged solutions for managing your network in outdoor. In addition, TGAP-6620+-M12 also provides P.D. feature on ETH2 which is fully compliant with IEEE802.3af PoE P.D. specification. Therefore, TGAP-6620-M12 is one of the best communication solutions for wireless applications.
Feature :
- High Speed Air Connectivity: WLAN interface support up to 300 Mbps link speed
- Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK(TKIP,AES)/802.1X Authentication supported
- Dual Gigabit Ethernet ports support Ethernet redundant mode (Recovery time < 10ms) and switch mode in M12 connector (A-coding)
- Support X-Roaming < 60 ms
- Support wireless load balance
- Support Multiple-SSID to 4 SSID
- Support external SMA antenna installation
- Support dual AP/Dual Client /Bridge /AP-Client Mode
- Support MAC Filter
- Wireless connecting status monitoring
- 1KV isolation for PoE P.D. port for TGAP-6620+-M12 • Secured Management by HTTPS
- Event Warning by Syslog, Email, SNMP Trap, and Relay output
- Rigid IP-40 housing design
- Wall-mount enabled
Specification :
TGAP-6620-M12 | TGAP-6620+-M12 | |
Physical Ports | ||
100/1000Base-T(X) Ports in M12 Auto MDI/MDIX (8-pin A-coding) | 2 | 2 (Present at ETH2 Fully Compiant with IEEE 802.3af PoE P.D.) |
DIDO port in M12 (A-Coding) | 2(DI x 4 and DO x 4) Dry Contact: On: short to GND, off: open Wet Contact(DI to COM/GND): On: 0 to 3VDC, off: 10 to 30VDC |
|
RS-232 Console port in M12 (5-pin A-coding) | 115200, 8 ,N ,1 | |
Antenna Connector | 4 | |
Relay port in M12 (5-pin A-coding) | 1A@24VDC | |
WLAN interface | ||
Operating Mode | AP/Bridge/Repeater/AP-Client | |
Antenna and connector | 4 x Reverse SMA Female | |
Radio Frequency Type | DSSS | |
Modulation | IEEE802.11b: CCK, DQPSK, DBPSK IEEE802.11a/g: OFDM with BPSK, QPSK, 16-QAM, 64-QAM IEEE802.11n: OFDM with BPSK, QPSK, 16-QAM, 64-QAM |
|
Frequency Band |
America/FCC: 2.412~2.462 GHz (11 channels) |
|
Transmission Rate | IEEE802.11b: 1 / 2 / 5.5 / 11 Mbps IEEE802.11a/g: 6 / 9 / 12 / 18 / 24 / 36 / 48 / 54 Mbps IEEE801.11n: up to 300Mbps |
|
Transmit Power | 802.11a: 12dBm ± 1.5dBm 802.11b: 18dBm ± 1.5dBm 802.11g: 15dBm ± 1.5dBm 802.11gn HT20: 13dBm ± 1.5dBm@150Mbps 802.11gn HT40: 12dBm ± 1.5dBm@300Mbps 802.11an HT20: 12dBm ± 1.5dBm@150Mbps 802.11an HT40: 12dBm ± 1.5dBm@300Mbps |
|
Receiver Sensitivity | 802.11a: -68dBm ±2dBm@54Mbps 802.11b: -85dBm ±2dBm@11Mbps 802.11g: -68dBm ±2dBm@54Mbps 802.11gn HT20: -68dBm ±2dBm@150Mbps 802.11gn HT40: -68dBm ±2dBm@300Mbps 802.11an HT20: -68dBm ±2dBm@150Mbps 802.11an HT40: -68dBm ±2dBm@300Mbps |
|
Encryption Security | WEP: (64-bit ,128-bit key supported) WPA/WPA2 :802.11i(WEP and AES encryption) WPAPSK (256-bit key pre-shared key supported) 802.1X Authentication supported TKIP encryption |
|
Wireless Security | SSID broadcast disable and enable | |
Protocol Support | ||
Protocol | ARP,BOOTP, DHCP, DNS, HTTP, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP, RSTP | |
LED Indicators | ||
Power Indicator | 2 x LEDs, Green for Power on | |
10/100/1000TX RJ45 Port Indicator | 2 x LEDs, Green for port Link/Act | |
WLAN LED | 2 x LEDs, Green for WLAN Link/Act | |
Fault | 1 x LED, Red for Ethernet link down or power down indicator | |
Fault contact | ||
Relay | Relay output to carry capacity of 1A at 24VDC(5-pin M12 A-coding) | |
Power | ||
Redundant Input Power | Dual Power Inputs. 12~48 VDC | |
Power Consumption (Typ.) | 11 Watts | 11.5 Watts |
Physical Characteristic | ||
Enclosure | IP-40 | |
Dimension (W x D x H) | 125.6(W) x 65(D) x 196.1(H) mm (4.94 x 2.55 x 7.72 inch.) | |
Weight (g) | 980 g | 985 g |
Environmental | ||
Storage Temperature | -40 to 85°C (-40 to 185°F) | |
Operating Temperature | -25 to 70°C (-13 to 158°F) | |
Operating Humidity | 5% to 95% Non-condensing | |
Regulatory approvals | ||
EMI | FCC Part 15, CISPR (EN55022) class A, EN50155 (EN50121-3-2, EN55011, EN50121-4) | |
EMS | EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS), EN61000-4-8, EN61000-4-11 | |
Shock | IEC60068-2-27, EN61373 | |
Free Fall | IEC60068-2-31 | |
Vibration | IEC60068-2-6, EN61373 | |
Safety | EN60950-1 | |
Warranty | 5 years |