IGR-20 series is a reliable VPN router with 2 ports 10/100/1000Base-T(X) router where ETH1 for LAN and ETH2 for WAN. It supports 802.1X and MAC filter for security control. It could be configured to operate in 2 modes of routing function: Dynamic/Static IP route, PPPoE authentication. In addition, IGR-20+ also provides P.D. feature on ETH2 which is fully compliant with IEEE802.3af PoE P.D. specification. This feature extends the layout up to 100 meters. Therefore, IGR-20+ is one of the best solution for applications of VPN connection.
Feature :
- High Speed Air Connectivity: WLAN interface support up to 300Mbps link speed
- Provide 2 port 10/100/1000Base-T(X) port
- Provide HNAT enhance LAN to WAN routing performance
- Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK(TKIP,AES)/802.1X Authentication supported
- Secured Management by HTTPs
- Various kind of WAN Connection Type supported: Dynamic/Static IP, PPPoE Dial Up
- IP table to prevent access from unauthorized IP address
- Support VPN for secured network connection (Open VPN , PPTP, IPSEC, VPN)
- Support NAT Setting (Virtual Server , Port Trigger , DMZ , UPnP)
- Versatile modes & event alarm by e-mail
- 1KV isolation for PoE P.D. port (IGR-20+)
- Event Warning by Syslog, Email, SNMP Trap, Relay and Beeper
- Rigid IP-30 housing design
- DIN-Rail and Wall-mount enabled
Specification :
IGR-20 | IGR-20+ | |
Physical Ports | ||
10/100/1000Base-T(X) Ports in RJ45 Auto MDI/MDIX | 2 | |
P.O.E. PD port | Present at ETH2 Fully compliant with IEEE 802.3af Power Device specifi cation Over load & short circuit protection Isolation Voltage : 1000 VDC min. Isolation Resistance :10^8 ohms min |
|
5-Pin Terminal Block | 2(4xDI and 4xDO) | |
LED Indicators | ||
Power Indicator | 3 x LEDs, PWR1(2)(PoE) / Ready: Red On : Power is on and booting up Green On : Power is on and functioning Normal |
|
10/100/1000T RJ45 Port Indicator | 2 x LEDs, LNK/ACT:Green for port Act. Speed: Green for port Link at 1000Mbps Amber for port Link at 100Mbps. Off for port Link at 10Mbps |
|
Fault | 1 x LED, Red for Ethernet link down or power down indicator | |
Fault contact | ||
Relay | Relay output to carry capacity of 1A at 24VDC | |
Power | ||
Redundant Input Power | Dual DC inputs. 12-48VDC on 6-pin terminal block | |
Power Consumption (Typ.) | 4W | 5W |
Overload Current Protection | Present | |
Reverse Polarity Protection | Present | |
Physical Characteristic | ||
Enclosure | IP-30 | |
Dimension (W x D x H) | 74.3(W) x 109.2(D) x 153.6(H) mm (2.93 x 4.3 x 6.05 inch.) | |
Weight (g) | 845g | 850g |
Environmental | ||
Storage Temperature | -40 to 85°C (-40 to 185°F) | |
Operating Temperature | -40 to 75°C (-40 to 167°F) | |
Operating Humidity | 5% to 95% Non-condensing | |
Regulatory approvals | ||
EMI | FCC Part 15, CISPR (EN55022) class A | |
EMS | EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS),EN61000-4-8, EN61000-4-11 | |
Shock | IEC60068-2-27 | |
Free Fall | IEC60068-2-32 | |
Vibration | IEC60068-2-6 | |
Safety | EN60950-1 | |
Warranty | 5 years |