IGAR-2062+-4G is a reliable IEEE 802.11 a/b/g/n WLAN VPN router with 2 ports 10/100/1000Base-T(X) router where ETH1 for LAN and ETH2 for WAN. It supports 802.1X and MAC filter for security control. It could be configured to operate in 3 modes of routing function: Dynamic/Static IP route, PPPoE authentication, and Modem dial up. In the mode of Modem dial up, it support GPRS/3G/3.5G/LTE modem by internal cellular module. Users can set up WLAN environment to fulfill demands of various applications rapidly by dual SIM dialing up cellular modems. In addition, IGAR-2062+-4G provides P.D. feature on ETH2 which is fully compliant with IEEE802.3af PoE P.D. specification. This feature extends the layout up to 100 meters. Therefore, IGAR-2062+-4G is one of the best solution for applications of wireless communication.
Feature :
- High Speed Air Connectivity: WLAN interface support up to 300Mbps link speed
- Provide 2 port 10/100/1000Base-T(X) port and 1 sim card slot
- Support dual 4G LTE dial up backup and load blance
- Provide HNAT enhance LAN to WAN routing performance
- Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK(TKIP,AES)/802.1X Authentication supported
- Secured Management by HTTPs
- Various kind of WAN Connection Type supported: Dynamic/Static IP, PPPoE, Modem/Dial Up
- Support client operating mode
- IP table to prevent access from unauthorized IP address
- Support VPN for secured network connection (Open VPN , PPTP, IPSEC VPN)
- Support NAT Setting (Virtual Server , Port Trigger , DMZ , UPnP)
- 3G Modem signal information display (un-connecting status)
- Wireless connecting status monitoring
- Versatile modes & event alarm by e-mail
- 1KV isolation for PoE P.D. port
- Event Warning by Syslog, Email, SNMP Trap, Relay and Beeper
- Rigid IP-30 housing design
- DIN-Rail and Wall-mount enabled
Specification :
| IGAR-2062+-4G | ||
| Physical Ports | ||
| 10/100/1000Base-T(X) Ports in RJ45 Auto MDI/MDIX | 2 | |
| P.O.E. PD port | Present at ETH2 Fully compliant with IEEE 802.3af Power Device specifi cation Over load & short circuit protection Isolation Voltage : 1000 VDC min. Isolation Resistance :10^8 ohms min |
|
| 5-Pin Terminal Block | 2(DI x 4 and DO x 4) | |
| Sim Card Slot | 2 | |
| Cellular Interface | ||
| Antenna Connector | 2 x SMA Fermale | |
| Cellualr Standard | GSM / GPRS/ EGPRS/ EDGE / WCDMA / HSDPA / HSUPA /LTE | |
| Band Option | America(US) LTE: 700/1700/2100/ MHz UMTS/HSDPA/HSUPA/HSPA+/DC-HSPA+: 800/850/1900/2100 MHz GSM/GPRS/EDGE: 850/900/1800/1900 MHz Europe(EU) LTE: 800/900/1800/2100/2600 MHz UMTS/HSDPA/HSUPA/HSPA+/DC-HSPA+: 900/2100 MHz GSM/GPRS/EDGE: 900/1800/1900 MHz |
|
| WLAN interface | ||
| Operating Mode | AP/Bridge/Repeater/AP-Client | |
| Antenna and connector | 2 x Reverse SMA Female | |
| Radio Frequency Type | DSSS | |
| Modulation | IEEE802.11b: CCK, DQPSK, DBPSK IEEE802.11a/g: OFDM with BPSK, QPSK, 16-QAM, 64-QAM IEEE802.11n: OFDM with BPSK, QPSK, 16-QAM, 64-QAM |
|
| Frequency Band | America / FCC: 2.412~2.462 GHz (11 channels ) 5.180~5.240 GHz & 5.745~5.825 GHz ( 9 channels ) Europe CE / ETSI: 2.412~2.472 GHz ( 13 channels ) 5.180~5.240 GHz ( 4 channels ) |
|
| Transmission Rate | IEEE802.11b: 1/ 2/ 5.5/ 11 Mbps IEEE802.11a/g: 6/ 9/ 12/ 18/ 24/ 36/ 48/ 54 Mbps IEEE802.11n:up to 300Mbps |
|
| Transmit Power | 802.11a: 12dBm ± 1.5dBm@54Mbps 802.11b: 17dBm ± 1.5dBm@11Mbps 802.11g: 16dBm ± 1.5dBm@54Mbps 802.11gn HT20: 15dBm ± 1.5dBm @MCS7 802.11gn HT40: 14dBm ± 1.5dBm @MCS7 802.11an HT20: 12dBm ± 1.5dBm @MCS7 802.11an HT40: 11dBm ± 1.5dBm @MCS7 |
|
| Receiver Sensitivity | 802.11a : -76dBm ± 2dBm@54Mbps 802.11b : -85dBm ± 2dBm@11Mbps 802.11g : -76dBm ± 2dBm@54Mbps 802.11gn HT20:-75dBm ± 2dBm@MCS7 802.11gn HT40:-72dBm ± 2dBm@MCS7 802.11an HT20:-74dBm ± 2dBm@MCS7 802.11an HT40:-71dBm ± 2dBm@MCS7 |
|
| Encryption Security | WEP: (64-bit ,128-bit key) WPA/WPA2 PSK :TKIP and AES encryption (802.11i) 802.1X/RADIUS Authentication supported |
|
| Wireless Security | SSID broadcast disable | |
| LED Indicators | ||
| Power Indicator | 3 x LEDs, PWR1(2)(PoE) / Ready: Red On : Power is on and booting up Green On : Power is on and functioning Normal |
|
| 10/100/1000T RJ45 Port Indicator | 2 x LEDs, LNK/ACT:Green for port Act. Speed: Green for port Link at 1000Mbps Amber for port Link at 100Mbps. Off for port Link at 10Mbps |
|
| WLAN LEDs | Green Solid On: RF on, Blink: data transmitting Green for WLAN Strength: 1<25%, 2<50%, 3<75%, 4<100% |
|
| WAN LEDs | 2 x LEDs, Green On : Power is on and functioning Normal | |
| Fault | 1 x LED, Red for Ethernet link down or power down indicator | |
| Fault contact | ||
| Relay | Relay output to carry capacity of 1A at 24VDC | |
| Power | ||
| Redundant Input Power | Dual DC inputs. 12-48VDC on 6-pin terminal block | |
| Power Consumption (Typ.) | 15W | |
| Overload Current Protection | Present | |
| Reverse Polarity Protection | Present | |
| Physical Characteristic | ||
| Enclosure | IP-30 | |
| Dimension (W x D x H) | 74.3(W) x 109.2(D) x 153.6(H) mm (2.93 x 4.3 x 6.05 inch.) | |
| Weight (g) | 1155 | |
| Environmental | ||
| Storage Temperature | -40 to 85°C (-40 to 185°F) | |
| Operating Temperature | -25 to 70°C (-13 to 158°F) | |
| Operating Humidity | 5% to 95% Non-condensing | |
| Regulatory approvals | ||
| EMI | FCC Part 15, CISPR (EN55022) class A | |
| EMS | EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS),EN61000-4-8, EN61000-4-11 | |
| Shock | IEC60068-2-27 | |
| Free Fall | IEC60068-2-32 | |
| Vibration | IEC60068-2-6 | |
| Safety | EN60950-1 | |
| Warranty | 5 years | |
